Using My Own Modem & Router With AT&T Fiber?

At first, you need to understand about how does it works and functions correctly. To make up your process change compiled. There are numerous reasons that you like to make use of personal routers that help for connecting up with the AT&T fiber. This helps for avoiding the router charges where you can easily use your routers for following out these processes that are listed below.

• To make use of your routers there you need to configure these features that will allow for connecting the two different routers that are used for connecting the single network that supports for avoiding the performance hindrance.
• This bridge mode works out by disabling the NAT features that are found on the modem that lets you track the conflict of the IP address by enabling the routers for functioning as the DHCP servers does.
• Here you will be allowed to set your gateway that supports for setting up your own routers into the AT & T gateways that avoid the wireless networks gateway.
• Certain limitations are kept for configuration when it cannot be linked up there the substations as the IP pass-through would help for getting the process to execute. However, this mode supports for making your system and network vulnerable to face online risks.

When you show interest in, there you have to know about some configuration set up. Two routes can wreak the havoc that is found in the network. Each of these routers would possess its private networks. Here the connected devices that are found around the house might create trouble interacting with each other.

To make the process change simple you can start configuring with the support of Bridge Mode. It enables the users for connecting the two different routers on one particular network. After this processes automatically the NAT (Network Address Translation) gets disabled. The features that is present in the modem that adds a protecting layer for the IP address through conflicting up the router for performing the DHCP-enabled services.

According to the AT & T-based modems or routers there you have to get the company-provided gateway. But after doing this you can directly start accessing it in your own router by linked it into the AT & T gateway that is used for enabling wireless-based operations. While undergoing this process there are some limitations kept for you to set  the bridge mode.

How should the configuration process start?

You must know the alternative things. The IP pass-through adds a high level of security for the data. It provides a firewall protective layer that can be accessed via AT&T fiber gateway methods. Even there are others ways are available for you to configure up your setup that depends based on which AT & T fiber routers/modem that you have. For determining this process you have to connect your device to the PC that too with the support of the Ethernet cable.

When you are connecting it to more than one device at the time you have to create a direct AT & T gateway and then start configuration is visible. If you are trying up with the DHCPS fixed there you have to specify the MAC address for that you can connect the PC directly to the browser. There you have to open the browser go to the firewall that is found on the GUI page. To process it there you have to enter the device access code, there choose the pass-through mode that is found on the allocation menu.

If you like to configure a manual process there you need to use your WAN IP address, default gateway, and subnet mask. However here is all the gateway information that is assigned over that supports for getting the different WAN IP and for processing it the true bridge mode is considered as the most desired router for configuration.

Simple steps for accessing

• Open the browser in your computer and redirect it to the router’s page setup. Make a note of the default IP address. There are only two possibilities that are 192.168.1.254 or 192.168.0.1.
• There login to the router page by entering the ID and password. When the login data are changed there you have to make use of the new details for accessing the setup page of the router.
• Navigate to the setting that is found on the menu then click on the LAN tab and select the DHCP.
• Enable the range by clicking on the radio button and change the router IP that is resigned there the primary routers are able for assigning the IP address.
• Save the settings by clicking, next, there is a need for preceding the steps that get involved through connecting the router with the AT&T fiber.